Abstract

Downer reactors have many advantages over risers for reactions requiring very short residence time. However, its application for reactions where a high solid/gas ratio is required has been restricted by the low solids holdup in the fully developed region (typically less than one percent). In this paper, we present the performance of a 0.078 m diameter and 3.2 m long high-density downer reactor equipped with a recently developed novel solids feeding system.

Experiments were carried out using fluid coke particles of particle density 1600 kg/m3 and mean diameter 133 mm, with solids fluxes up to 1400 kg/m2s and superficial gas velocities ranging from 0 to 6 m/s. The downer was operated under batch mode, with solids fed from a solids feeder installed inside a fluidized bed at the top of the downer and the bottom end of the downer connected to a receiving hopper. The solids flux was controlled by a butterfly valve installed 0.4 m below the downer entrance. Air was injected into the downer through four 45-degree-angled nozzles located right below the butterfly valve. Solids were lifted up from the bottom receiving-hopper to the upper fluidized bed through an external riser after each run.

The cross-sectional average solids hold-up calculated from the integration of local measurements obtained from a capacitance probe was found to be a function of both the solids flux and superficial gas velocity. The solids hold-up increased with increasing solids flux at a given superficial gas velocity, but decreased with increasing gas velocity at a fixed solids flux. A cross-sectional average solids holdup of 16.5% was achieved at an axial position of 3.0 m below the air injection point under the operating condition of Gs=1400 kg/m2s and Ug=2.0 m/s. The shape of radial solids distribution varied not only with the superficial gas velocity but also with the solids flux in high-density downers. The radial solids distribution became more uniform under higher solids fluxes and lower gas velocities. The dense ring at the near wall region disappeared under the high-flux operating condition (Gs=1400 kg/m2s, Ug=2.0 m/s). The radial solids holdup profiles became less uniform, denser near the wall and more dilute and non-uniformly distributed in the central region, as the gas velocity increased from 3.0 to 6.0 m/s at a fixed solids flux of about 400 kg/m2s, which is significantly different from flow patterns reported in the literature under lower solids flux conditions.

Recommended Citation

Song, Xuqi; Bi, Xiaotao T.; and Bolkan, Yasemin (2005) "Hydrodynamics of High-Density Downer Reactors Using a Novel Solids Feeder," International Journal of Chemical Reactor Engineering: Vol. 3: A52.
Available at: http://www.bepress.com/ijcre/vol3/A52